Meta analytics pixel
Our customers rate us 4.9 out of 5on Google4.9 · Google reviews

Hours: 7am to 7pm, 7 days

A grey tile-pattern stamped patio enclosed by a tall wood privacy fence
Concrete advice · Greer, SC

Cleaning Stamped Concrete in Greer, SC

Yes. You can pressure wash stamped concrete in Greer, SC, and sealer makers expect it before a reseal. Brickform's Gem-Seal sheet calls for at least 3,000 psi at 4 gallons a minute, with nylon brushes to reach the imprint. Between reseals, Brickform says a neutral cleaner and clean water are enough.

By the Ace Concrete Construction crew · Greer, SC · Published November 18, 2026

The color and pattern on stamped concrete sit at the surface under a film of sealer, so washing it is as much about the sealer as the dirt. Ace Concrete Construction pours stamped and colored slabs out of Taylors, and our page on stamped and decorative concrete in the Upstate covers the pour itself.

Below is how hard to wash and when a wash turns into a reseal, then the months of the year checked against the NOAA record from the weather station at Greenville-Spartanburg International Airport, which NOAA lists under Greer. Permits and county lines in town are on our page about concrete work in Greer. Part of Greer lies in Spartanburg County, where we also keep an office, listed on our page for a concrete contractor in Spartanburg, SC.

How much pressure can stamped concrete take?

Enough to get into the texture. The published figures for cleaning a stamped slab before it is sealed start at 3,000 psi.

Brickform's technical sheet for Gem-Seal 700 VOC, a solvent-based acrylic sealer it lists for stamped and colored concrete, says pressure washers used to clean slabs should run at a minimum of 3,000 psi at 4 gallons per minute. It adds that a rotary floor scrubber used on a stamped slab needs nylon bristle brush attachments, because pads do not reach the imprinted areas.

The Decorative Concrete Council of the American Society of Concrete Contractors (ASCC) sets the bar a little higher. Its best-practice sheet on sealing stamped concrete calls a power washer of at least 3,500 psi the most effective and efficient cleaning method, and for a reseal it recommends that pressure followed by 24 hours of drying time.

Both figures describe getting a slab ready for sealer, not a weekly rinse.

A grey tile-pattern stamped patio with a built-in fire pit and a worker finishing the edge
Ace project photo · A stamped patio being finished at the edge on one of our jobs.

Do you need a pressure washer to keep stamped concrete clean?

No. For most sealers, Brickform's guide to sealing stamped concrete says regular cleaning with a neutral cleanser and clean water is all the sealer needs.

Put that next to the 3,000 and 3,500 psi figures above and the pressure washer is really a reseal-day tool, with the hose and a neutral cleaner doing the work in between.

What does a pressure wash do to old sealer?

It lifts sealer that is already failing. ASCC lists a high-pressure washer, along with sand or soda blasting and chemical strippers, as a way to remove loose, flaky or discolored acrylic sealer before a new coat goes on.

That makes the wash a useful test. Patches that come away under the wand are the loose, flaky sealer ASCC says has to go before a reseal.

Brickform's guide says that when you reuse the same sealer, cleaning and a light profile are usually enough, while heavy deterioration, sealer failure or a change of sealer means stripping the old coat and starting fresh. ASCC says the exact same sealer as last time always gives the best result, and that a small test area should come first when a new sealer goes over an existing solvent-based one.

How do you know stamped concrete needs resealing?

Pour a little water on it. Brickform says a properly sealed surface makes water bead up, while an unsealed one soaks it in quickly.

ASCC says reseals should happen as needed rather than on a set number of years, and names lost water and stain repellency and lost depth of color as the main reasons to reseal. It also warns that resealing every year to keep a high gloss builds up a film that is slow and expensive to remove. Brickform's own guide puts it at every few years, according to wear.

Brickform's guide says unsealed stamped concrete can lose color quickly to UV exposure, takes stains into the porous surface, and is more likely to crack through freeze-thaw because it cannot keep moisture out. The Gem-Seal sheet adds one more check for the reseal itself: if water still beads on a surface you have prepared, it needs more cleaning before sealer will bond.

A blue-grey ashlar-pattern stamped driveway beside a light blue house
Ace project photo · A stamped driveway with an ashlar pattern on one of our jobs.

When is the best time of year to wash and reseal stamped concrete in Greer?

Early to mid fall fits best on the Greer weather record. October averages fewer days with rain than any other month, with average highs inside the range Brickform gives for applying Gem-Seal.

A reseal needs a run of dry weather. ASCC asks for 24 hours of drying after the power wash, the Gem-Seal sheet says not to apply on rainy or foggy days and to keep foot traffic off for 24 hours afterward, and it sets the air temperature for application between 50°F and 85°F. That adds up to about two dry, mild days in a row, plus a quiet day after.

NOAA's 1991 to 2020 climate normals for the Greer station (USW00003870) show how often Greer gets that. The station averages 116.9 days a year with measurable precipitation (0.01 inch or more) and 49.67 inches of it in total (NOAA annual normals). The monthly normals break it down:

MonthAverage highAverage lowDays with measurable rainDays at 90°F or hotter
April73.2°F48.7°F9.70.1
May80.3°F57.5°F9.72.1
June87.2°F65.5°F10.810.3
July90.3°F69.2°F12.017.5
August88.5°F68.3°F11.112.6
September82.7°F62.4°F8.04.7
October73.1°F50.4°F7.10.2
November62.9°F40.4°F8.50.0

July is the wettest month by rain days and its average high of 90.3°F sits above the Gem-Seal ceiling of 85°F. Across June, July and August the station averages 33.9 days with measurable rain, against 23.6 for September through November.

If a summer reseal can't wait, time of day matters. The Gem-Seal sheet says to apply early or late in the day when it is cooler, and ASCC's rule of thumb is to seal when the slab temperature will be falling for 3 to 4 hours afterward, which it says can mean evening is the only option. Those are 30-year averages, so check the forecast for the week you pick.

Can a fresh coat of sealer make stamped concrete slippery?

It can if it goes on too heavy. The Gem-Seal sheet says to apply it in thin coats, only on surfaces textured for slip resistance, and warns that a heavy coat can become slippery, especially where water collects.

The same sheet says two to three light coats are better than one heavy coat in hot weather, and that each coat should be tack free before the next. ASCC adds that applying sealer too thick or in too many coats affects breathability and bond, and it names spray and back roll as the preferred method on textured stamped concrete, because dip-and-roll tends to leave uneven, over-applied coats.

On pool decks and walks that stay wet, ask about a grit additive in the sealer too. Our guide to settling a stamped concrete job before the pour covers grit and the first seal date on a new slab.

Questions about stamped concrete care in Greer

Should you seal stamped concrete?

Yes. Brickform says stamped driveways, patios and sidewalks need sealer to protect them from stains, discoloration and moderate wear, and that sealer deepens the color. ASCC gives the purpose as keeping out water and deicing compounds, resisting stains and bringing out the look of the stamped finish. Brickform also says an unsealed surface soaks up water quickly.

What is the best sealer to put on stamped concrete?

ASCC says topical film-forming sealers are the most common choice on stamped work because they enhance color. Penetrating water repellents protect against water and staining, though most do not deepen color. Hybrid sealers do some of both. On an older slab, ASCC says the same sealer as last time gives the best result.

Can I apply a second coat of concrete sealer the next day?

Usually yes, if the label allows it. Brickform's Gem-Seal sheet only asks that the first coat be tack free before the next one goes on, and it keeps foot traffic off for 24 hours after the last coat, or 72 hours for heavy traffic. Other sealers have their own recoat times, so read your product's sheet.

On the job

What does a driveway pour look like on video?

A driveway going in: base prepped, forms set and braced, then the pour worked and finished before it sets.

Get a free estimate

Reviews

See why Greenville and Upstate, SC residents choose us

Real Google reviews from customers across the Upstate.
Verified customer
Ace concrete was excellent. They did a wonderful job. Very great experience with the workers and was very surprised that the owner showed up at the job and he actually did smoothing of…
Google review
Verified customer
Ace installed a small patio on a sloping area requiring a poured concrete wall on one side. They removed the existing patio block structure and installed the concrete patio in one day. The results were fantastic…
Google review
Verified customer
Ace knocked it out the park for me on a large concrete driveway pour in Taylors, SC.…
Google review
Verified customer
Great job, the pad for our generator is perfect I highly recommend
Google review
Verified customer
I needed a 24' x 40' concrete floor for a metal building. After getting several quotes I decided to go with Ace Concrete Construction.…
Google review
Verified customer
Great work team was finished in a day and all the areas look great.
Google review

Read all our Google reviews

Licence

Who Ace Concrete Construction is, where it works, and under what licence

Ace Concrete Construction holds South Carolina residential builder licence RBS.65343 and a member listing in the Home Builders Association of Greenville directory.

Get a free estimate

Get your free concrete estimate

We price the job on site. Open Mon–Sun 7am–7pm.

Free estimate

Tell us about the job

Someone comes out and prices it standing on it. Estimates are free.

  • Driveways
  • Patios & Outdoor Living
  • Decorative Concrete
  • Garage & Building Slabs
  • Foundation & Retaining Walls
  • Commercial Concrete
  • Industrial Concrete
  • Epoxy Flooring
  • Foundation Repair & Concrete Restoration

Financing available through Wisetack. Check your options in about a minute without impacting your credit score.

See financing options

*All financing is subject to credit approval. Your terms may vary. Payment options through Wisetack are provided by our lending partners.

Fast & Free

Get Your Free Concrete Estimate

4.9 · Google Reviews

No pressure. Someone comes out and prices the job standing on it.

Call 864-214-5271